ROUND BRAKE LATHE BITS
The finest
cutting system in the industry...
Cut Rotors Five Times Faster!
The "Original" Round Bits
GWR has the original and highest quality
rotor finishing system in the industry because of our exclusive "lock washer"
hold down... there is no equal on the market! A simple tightening of the screw
prevents the bit from turning or chattering, unlike other versions being sold through some
parts distributors.
Are you ready to...
Saves 10 to 20 minutes on every brake rotor service
(We eliminate the slow final cut)
Produce up to 25% smoother rotor finishes (RA)
Extend bit life nearly 3 to 1 over stock triangular bits
...then you need to
order our "Starter Kit" above!
(Order #65-0066K and please specify
brand of lathe)
GWR "Round Bit" Starter
Kit.... $79.95
2 H.D. Tool Holders with 2 "Patented" Clamps, plus 2 "Round" Bits
Note: Two round bits can cut over 100 rotors
(This internet promotion is about $40 off the suggested list price)
To Order Simply Call 1(800) 266-4497
Why does it work better???
With each revolution of your lathe, the unique larger footprint of round bits allows more surface contact with the rotor. This produces a cut zone of about 150% to 200%, when compared to the area cut by a stock bit during a similar rotation.
The continual, partial overlap of the previous revolution results in a rotor finish like that of a double cut... yet only one pass is required.
The taper design of the cutting edge (exclusive of round bits) allows for easier removal of old rotor material. Metal is sliced off less aggressively, rather than being torn or ripped off the surface. This allows improved heat control to extend bit life and it nullifies the normal high RA finish common with OE triangular style bits.
Cut chips fly more easily from the bit/rotor contact surface because there is no need to "push" them out of the way before continuing with the cut.
No
need to remove additional metal from rotor during the 2nd cut (finishing cut)
when your 1st cut (rough cut) trues the runout and removes the grooves from the surface.
On
average, rotors turned with GWR "Round Bits" have an Ra (roughness average
measurement) 25% less than those cut with triangle type bits. It is a
fact!
Tens
of Thousands of
quality shops throughout the US and overseas use these bits everyday...
can you afford not
to change to the latest brake lathe cutting technology?
GWR "Round Bit"
Starter Kit.... $79.95
2 H/Duty Holders, 2 "Patented" Clamps,
plus 2 Round Bits
"Note that this Kit can cut over 100 rotors"
(Internet promotion, about $40 off the Suggested List Price)
To Order Simply Call 1(800) 266-4497
GWR Specialty Automotive Parts Copyrighted 1996 - 2017 1 (800) 266-4497 Email: sales@gwrauto.com |